Save 5% off any order over $500 with Promo Code "FIVE" at checkout.


Our Products: Komatsu

Rubber Pads Komatsu PC35 Steel Chains

Komatsu PC35 Bolt-on Rubber Pads
Rubber Pads Komatsu PC35 Steel Chains
Replacement bolt-on rubber pads for steel tracks on the Komatsu PC35 excavator series. This 300mm (almost 12 inches) wide pad fits a variety of the manufacturer's mini excavator models. Verify your bolt pattern prior to ordering. Give us a call for a bolt pattern measurement guide so we can get you the correct rubber pad every time. Protect the streets from steel track damage by using bolt-on rubber pads.
Weight: 4 lbs
Make: Komatsu
Shipping: Fast and Free!
Price: $29.00

Rubber tracks and wear parts are sold individually unless specified in the details. We offer free shipping across the USA when you order online and ship to a commercial address. *Some restrictions apply.

Bolt-On Rubber Pads for Komatsu PC35 Mini Ex Steel Tracks

We stock heavy-duty Komatsu PC35 replacement rubber pads for steel track groups. Rubber pads are priced individually in case you just need to replace one damaged pad. These smaller pads only require two bolts per pad to be installed through the pre-drilled holes in your steel track grouser. If you do not have pre-drilled installation holes in your steel tracks, you may want to consider a clip-on rubber pad or give us a call for your best options. These pads are designed to fit steel tracks with pre-drilled holes in the grouser for the following models:

Komatsu Steel Track Models

This bolt-on rubber pad is known to fit:

  • Komatsu PC25
  • Komatsu PC27MR
  • Komatsu PC27MR-2
  • Komatsu PC27MR-3
  • Komatsu PC27R-8
  • Komatsu PC28UU-2
  • Komatsu PC30
  • Komatsu PC35
  • Komatsu PC35MR-2
  • Komatsu PC35MR-3
  • Komatsu PC35MR-5
  • Komatsu PC38UU-2

Rubber Pad Specification

This bolt-on rubber pad has the following specifications:

  • Pad Width: 300mm
  • Chain Pitch: 101mm
  • Bolt Size: M12
  • Torque: 60 ft/lbs.

Bolt-On Rubber Pad Advantages

The bolt-style traditional rubber pad is designed for long-term projects as opposed to a quick change from a variety of job site terrain. If you need rubber pads for a long-lasting project then it is worth the extra time to use the bolt-style traditional rubber pad. These pads are full-width so the steel grouser does not extend beyond the protection of the rubber pad. This helps protect against curb damage. The standard rubber pad is the most secure protection for a triple grouser.

These are the industry standard type bolt-on rubber pads that attach to your steel grouser through the existing pre-drilled bolt holes. There are two bolt holes, one on each side of the grouser. Rubber pads include 10.9 grade M12x1.75 nuts and M12 washers required for installation on the steel grousers. Verify your manufacturer's suggested torque settings for up to 60 foot-pounds.