Free Shipping to commercial address. *Restrictions apply


Bolt-On Rubber Pads Case CX145

Bolt-on Rubber Pads for Case CX145
Bolt-On Rubber Pads Case CX145
Replacement bolt-on rubber pads for steel tracks on the Case CX135 and CX145 excavators. This 500mm (almost twenty-inch) wide pad fits a variety of makes and models in the full-size excavator range. Four bolts provide a long-term secure installation for your project. Protect the streets from steel track damage by using bolt-on rubber pads.
Weight: 12 lbs
Make: Case
Shipping: Fast and Free!
Price: $67.00

Rubber tracks and wear parts are sold individually unless specified in the details. We offer free shipping across the USA when you order online and ship to a commercial address. *Some restrictions apply.

Bolt-On Rubber Pads for Case CX145 Steel Tracks

We supply traditional-style bolt-on replacement rubber pads for steel track groups. Replacement pads are priced individually. These pads are designed to fit steel tracks for the following models:

Case Steel Track Models

This bolt-on rubber pads is known to fit:

  • Case CX130
  • Case CX130B
  • Case CX135
  • Case CX135SR
  • Case CX145
  • Case CX145C
  • Case CX145C SR
  • Case CX145D
  • Case CX145D SR

Rubber Pad Specification

Case CX145 rubber pad specification:

  • Pad Width: 500mm
  • Pad Length: 124mm
  • Bolt Width Spacing: 400mm
  • Bolt Length Spacing: 58mm
  • Triple Grouser Clearance: 14mm
  • Bolt Size: M16

Bolt-On Rubber Pad Advantages

The four-bolt style traditional rubber pad is designed for long-term projects as opposed to a quick change from a variety of job site terrain. If you need rubber pads for a long-lasting project then it is worth the extra time to use the four-bolt style traditional rubber pad. These pads are full-width so the steel grouser does not extend beyond the protection of the rubber pad. This helps protect against curb damage. The four-bolt standard rubber pad is the most secure protection for a triple grouser.

These are the industry standard type bolt-on rubber pads that attach to your steel grouser through the existing pre-drilled bolt holes. There are four bolt holes, two on each side of the grouser. The bolt holes are spaced out sixteen inches on center across the grouser and are fifty-eight millimeters across the grouser plate. Rubber pads include the M16 nuts required for installation on the grousers.