Free Shipping to commercial address. *Restrictions apply

Store

Our Products: Doosan Tracks

Bolt-On Rubber Pads Doosan DX140LCR

Bolt-on Rubber Pads for Doosan DX140
Rubbertrax
Bolt-On Rubber Pads Doosan DX140LCR
Replacement bolt-on rubber pads for steel tracks on the Doosan DX 130 and DX140LCR excavators. This 500mm (almost twenty-inch) wide pad fits a variety of makes and models in the full-size excavator range. Four bolts provide a long-term secure installation for your project. Protect the streets from steel track damage by using bolt-on rubber pads.
SKU: BOLTPADSDOOSANDX140
Weight: 12 lbs
Make: Doosan
Shipping: Fast and Free!
Price: $67.00

Rubber tracks and wear parts are sold individually unless specified in the details. We offer free shipping across the USA when you order online and ship to a commercial address. *Some restrictions apply.

Bolt-On Rubber Pads for Doosan DX140LCR

We supply traditional-style bolt-on replacement rubber pads for steel track groups. Replacement pads are priced individually. These pads are designed to fit steel tracks for the following models:

Doosan Steel Track Models

This bolt-on rubber pad is known to fit:

  • DOOSAN DX130
  • DOOSAN DX130LCV
  • DOOSAN DX140
  • DOOSAN DX140LC
  • DOOSAN DX140R
  • DOOSAN DX140LC-5
  • DOOSAN DX140LCR-5

Rubber Pad Specification

Doosan rubber pad specification:

  • Pad Width: 500mm
  • Pad Length: 124mm
  • Chain Pitch: 171mm
  • Bolt Width Spacing: 400mm
  • Bolt Length Spacing: 58mm
  • Triple Grouser Clearance: 14mm
  • Bolt Size: M16

Bolt-On Rubber Pad Advantages

The four-bolt style traditional rubber pad is designed for long-term projects as opposed to a quick change from a variety of job site terrain. If you need rubber pads for a long-lasting project then it is worth the extra time to use the four-bolt style traditional rubber pad. These pads are full-width so the steel grouser does not extend beyond the protection of the rubber pad. This helps protect against curb damage. The four-bolt standard rubber pad is the most secure protection for a triple grouser.

These are the industry standard type bolt-on rubber pads that attach to your steel grouser through the existing pre-drilled bolt holes. There are four bolt holes, two on each side of the grouser. The bolt holes are spaced out sixteen inches on center across the grouser and are fifty-eight millimeters across the grouser plate. Rubber pads include 10.9 grade M16x2 nuts and M16 washers required for installation on the triple grousers. Verify your manufacturer's suggested torque settings for up to 90 foot-pounds.