John Deere CT 322 Aftermarket Rubber Tracks

18-Inch 450x86x52 Rubber Tracks

This is the aftermarket replacement rubber track for John Deere compact track loaders. The tread pattern shown is the actual tread pattern you will receive so if you have a tread pattern preference please specify. The track is eighteen inches (450 mm) wide with fifty two links. This rubber track is the widest option to fit the John Deere CT322 so please verify you have clearance for the eighteen-inch wide track prior to ordering.

This track has fifty-two metal links down the center. Some John Deere CT 322 and New Holland models can have fifty-six links so please verify prior to ordering.

This track comes with a standard warranty against manufacturer defects. If sprockets are purchased and installed together with the tracks, it will maximize the lifespan of your tracks. Always consider changing your sprockets and any worn undercarriage parts when you change your tracks. Rubber tracks and sprockets are designed to wear together and changing sprockets at any other time would reduce the lifespan of both the track and the sprocket. Other worn parts can affect the tensioning of the track and can cause de-tracking and other wear issues.

Tread Patterns Commonly Available

	The off-set block tread pattern is the most general purpose tread pattern for widespread job site applications. Adequate traction with maximum floatation helps prevent damage to sensitive areas while still providing enough traction for typical job sites.
	This tread pattern allows for maximum traction in a wide variety of applications including mud, snow, and slopes. The additional tread depth gives you more forward traction with just enough jagged zig-zag edges to provide traction on a sliding slope.
	The off-set C tread pattern is common among original equipment manufactures because it gives significant forward traction and grip as well as extra traction provided by the C shaped pads when operating across a slope, even though that is not suggested practice.